NX二次开发，按点和方向创建草图

按点和方向创建草图，并添加草图曲线

#include <NXOpen\Session.hxx>
#include <NXOpen\PartCollection.hxx>
#include <NXOpen\WCS.HXX>
#include <NXOpen\CartesianCoordinateSystem.hxx>
#include <NXOpen\NXMatrix.hxx>
#include <NXOpen\SketchCollection.hxx>
#include <NXOpen\SketchInPlaceBuilder.hxx>
#include <NXOpen\Plane.hxx>
#include <NXOpen\ScalarCollection.hxx>
#include <NXOpen\PointCollection.hxx>
#include <NXOpen\Point.hxx>
#include <NXOpen\DirectionCollection.hxx>
#include <NXOpen\Direction.hxx>

//创建草图
//iPoint：关联曲线上的点
//iCurve：关联曲线
//iCurves：要添加到草图的曲线
NXObject* CreateSketch(Point3d iPoint, tag_t iCurve, vector<tag_t> iCurves)
{
	if(iCurve==NULL_TAG || iCurves.size()==0)
		return NULL;

	Part* workPart = Session::GetSession()->Parts()->Work();
	Matrix3x3 Mtx = workPart->WCS()->CoordinateSystem()->Orientation()->Element();

	Session::GetSession()->BeginTaskEnvironment();
	SketchInPlaceBuilder* sketchBuilder = workPart->Sketches()CreateNewSketchInPlaceBuilder(NULL);
	sketchBuilder->SetPlaneOption(Sketch::PlaneOptionNewPlane);//设置平面方法
	//创建新平面
	sketchBuilder->Plane()->SetMethod(PlaneTypes::MethodTypePointDir);//创建平面的方式
	Scalar* scalar1 = workPart->Scalars()->CreateScalar(0.0,Scalar::DimensionalityTypeNone,SmartObject::UpdateOptionWithinModeling);
	Curve* vCurve = dynamic_cast(Curve*)(NXObjecyManager::Get(iCurve));
	Point* origin = workPart->Points()->CreatePoint(vCurve, scalar1,SmartObject::UpdateOptionWithinModeling);
	Vector3d vecZ(Mtx.Zx, Mtx.Zy,Mtx.Zz);
	Direction* direction1 = workPart->Directions()->CreateDirection(iPoint, vecZ,SmartObject::UpdateOptionWithinModeling);
	vector<NXObject*> geom1(2);
	geom1[0] = origin;
	geom1[1] = direction1;
	sketchBuilder->Plane()->SetGeometry(geom1);
	//设置草图原点
	sketchBuilder->SetSketchOrigin(origin);

	NXObject* nxobject1 = sketchBuilder->Commit();
	sketchBuilder->Destroy();
	Session::GetSession()->EndTaskEnvironment();

	//添加草图曲线
	Sketch* sketch1 = dynamic_cast<Sketch*>(nxobject1);
	sketch1->Activate(Sketch::ViewReorientFalse);//激活草图
	for(int i=0; i < iCurves.size();i++)
		sketch1->AddGeometry(dynamic_cast<Curve*>(NXObjecyManager::Get(iCurves[i])));
	sketch1->Deactivate(Sketch::ViewReorientFalse, Sketch::UpdateLevelModel);//完成草图

	return nxobject1;
}