华为框式交换机S12700E系列配置CSS集群

原创

已于 2024-04-15 10:41:16 修改 · 2.5k 阅读

标签

#华为 #网络 #网络协议 #css

收录于

于 2024-04-15 10:16:58 首次发布

搭建集群环境

a.为两台交换机上电，按照数据规划分别对两台框式交换机进行配置

<HUAWEI> system-view 
[HUAWEI] sysname Switch1
[Switch1] set css id 1 
[Switch1] set css priority 150  //框1的集群优先级配置为150
[Switch1] interface css-port 1
[Switch1-css-port1] port interface xgigabitethernet 4/0/1 to xgigabitethernet 4/0/2 enable
[Switch1-css-port1] quit
[Switch1] interface css-port 2
[Switch1-css-port2] port interface xgigabitethernet 5/0/1 to xgigabitethernet 5/0/2 enable
[Switch1-css-port2] quit
[Switch1] display css status saved  //查看集群配置是否正确  
CSS port media-type: SFP+                                                              
Current Id   Saved Id     CSS Enable   CSS Mode    Priority    Master force      
------------------------------------------------------------------------------  
1            1            Off          LPU         150         Off   

[Switch1] css enable  //集群配置确认正确后，使能集群，重启设备，为保证框ID成为主交换机，先重启Switch1
Warning: The CSS configuration will take effect only after the system is rebooted. The next CSS mode is CSS card. Reboot now? [Y/N]:y

<HUAWEI> system-view 
[HUAWEI] sysname Switch2
[Switch2] set css id 2  //框2的集群优先级使用缺省值，不需要配置。
[Switch2] interface css-port 1
[Switch2-css-port1] port interface xgigabitethernet 4/0/1 to xgigabitethernet 4/0/2 enable
[Switch2-css-port1] quit
[Switch2] interface css-port 2
[Switch2-css-port2] port interface xgigabitethernet 5/0/1 to xgigabitethernet 5/0/2 enable
[Switch2-css-port2] quit
[Switch2] display css status saved //查看集群配置是否正确
CSS port media-type: SFP+