ubuntu配置ftp

on the IPv6 “any” address (:😃 will accept connections from both IPv6

and IPv4 clients. It is not necessary to listen on both IPv4 and IPv6

sockets. If you want that (perhaps because you want to listen on specific

addresses) then you must run two copies of vsftpd with two configuration

files.

listen_ipv6=YES

Allow anonymous FTP? (Disabled by default).

anonymous_enable=NO

Uncomment this to allow local users to log in.

local_enable=YES

Uncomment this to enable any form of FTP write command.

write_enable=YES

Default umask for local users is 077. You may wish to change this to 022,

if your users expect that (022 is used by most other ftpd’s)

local_umask=022

Uncomment this to allow the anonymous FTP user to upload files. This only

has an effect if the above global write enable is activated. Also, you will

obviously need to create a directory writable by the FTP user.

#anon_upload_enable=YES

Uncomment this if you want the anonymous FTP user to be able to create

new directories.

#anon_mkdir_write_enable=YES

Activate directory messages - messages given to remote users when they

go into a certain directory.

dirmessage_enable=YES

If enabled, vsftpd will display directory listings with the time

in your local time zo