(Tower) Magnetic Cup Dryer / Reusable Adhesive

Yamazaki Industries 5487 Magnetic Tumbler with Film Hook, Tower, White

Keeps tumbler floating with magnets.

Since it can be floated in the air, the tumbler will not become slim, and is hygienic.Holder is easy to install with film hooks.

Product Size: Approx. 2.8 x 2.8 x 3.7 inches (7 x 7.5 x 12.5 cm); Film Hook Size: Approx. W 2.8 x D 2.2 x H 2.8 inches (7 x 5.5 x 7 x 7 cm); Film Hook: Glossy flat surface (surface larger than the adhesive surface of the film hook, tile, plastic surface, stainless steel, refrigerator, washing machine, etc.) Steel wall capacity: 20. Heat Resistance: 0 mL Tumbler: 194°F (90°C), Film Hook: 140°F (60°C), Cold Resistance: -40°C; Quality Display: Tumbler: ABS resin; Magnet Film Hook (Hook Part: ABS resin; Steel (Unichrome Plating); Film Surface: Polycarbonate Film Interior: PET Film Adhesive Surface, Cushion: Silicone); *Please be aware that there is a risk of counterfeit product if the seller or ship from Japan.

Precautions for Use:

Please note that this may cause falling, dropping, injury, damage, deformation, discoloration, ground scratches, deterioration, deformation, rust, etc. Do not use for anything other than the intended purpose. Please stick to a glossy flat surface with film hooks attached. After installation, please check that the film hook is firmly attached before using. If there is dirt or dust on the surface of the film or the adhesive surface, it will not stick to it.Please install the adhesive surface with clean surface. Please do not apply boiling water (over 140°F (60°C) or higher) to the film hook or leave it in hot water or water. Please do not use terpene and oil contained in the citrus skin may deteriorate. If liquid or other liquids adheres to the surface of the product, it may cause defects, so we recommend wiping it off or cleaning it immediately. Adhesive force may vary slightly depending on surface processing, material, condition, painting, strength, environmental etc. When attaching the tumbler to a wall, please stick it to a flat surface with no uneven magnets. When attaching the tumbler to the wall, please make sure the entire magnet is attached to the wall and the product is fixed and stable. When installing the tumbler on a wall, it may differ depending on the thickness of the iron on the wall, the material of the installation surface, the condition, painting, strength, and environment. Please be aware that due to large impacts, the product may fall off and cause injury or damage. We cannot assume responsibility for unavoidable forces such as celestial disasters, inadvertance of customer handling, insufficiencies, faulty or failure in installation method. Do not use in places exposed to direct sunlight or open flames, or in places where it gets hot. If you leave it on the same place for a long time, there may be mold, mildew, wrinkle, or discoloration on the wall or the back of the film hook. Please clean the ground surface once a few months and reposition the film hooks. Film hooks may deteriorate or damage over long periods of use.Also, if any abnormalities occurred during use, please stop using it immediately.

Care Instructions

● The surface of the film hook can be cleaned gently with water or warm water, and then dried thoroughly. The adhesive side of the film hook should be lightly rubbed on the abdomen of your finger.Do not use detergents or other similar Wash the tumbler with a mild detergent and wipe away any moisture before using. Please be aware that rubbing with scrubbing scrubbing with scrubbing powder, etc., may cause scratches. Do not use chemical such as mold remover or bleach or solvents such as benzene or thinner.